Precor TRM 800 Assembling And Maintaining Manual page 36

34
Cable
TV in
Power
Data from base unit
Heart rate sensors
Safety key
(treadmills only)
CSAFE
Auto Stop sensor
(treadmills only)
To simplify installation and maintenance, route and connect
cables 1 through 5 according to the following instructions.
Note: In the illustrations in this section, some cables are
omitted for the sake of clarity.
Connecting the Television Cable
The console's television tuner is mounted inside the console's
back plate. The tuner includes a short cable adapter that
allows the television cable to be connected outside the back
plate.
To connect the television cable:
1.
2. Route the cable counterclockwise around the outside of
3. Attach the connector on the cable to the connector on the
4. Use a plastic tie to secure the connectors to the top of the
Assembling and Maintaining TRM 800-Series Treadmills
Connector Type
F-type coaxial
Two-contact plug,
polarized and latched
Eight-contact modular, on
flat gray cable
Four-contact strip, keyed
Six-contact strip, keyed
Eight-contact modular, on
flat gray cable
Four-contact strip, keyed
Pull the cable out through the lower right corner of the
back plate.
the back plate.
tuner cable and tighten the two connectors securely using
two ⁷₁₆-inch open-end wrenches. Position both
connectors above the upper right corner of the back plate.
back plate. Pass the tie through the two small holes near
the upper right corner of the back plate, then wrap it
around the connectors and tighten it securely. Cut off and
remove the protruding end of the tie.
Circuit
Connector
Location