Precor TRM 800 Assembling And Maintaining Manual page 23

Assembling the Treadmill
3. Secure the right-hand upright support to the side bracket
4. Using the fabric connectors provided, attach the power
5. Route the DC output cable of the power supply through
6. Connect the black three-conductor plug on the AC wiring
using four socket head screws, four black washers, and
two locknuts. Partially tighten the fasteners.
Figure 7: Upright support attachment, right side
supply to the right-hand side of the front crossmember on
the treadmill base. (The gray rectangle in the following
illustration shows where you should mount the power
supply.)
the clips between the power supply and the belt motor.
Pass the end of the cable under the mounting bracket for
the lift motor.
harness to the socket on the power supply.
21