Precor TRM 800 Assembling And Maintaining Manual page 34

32
Important: Before you begin the following procedure, remove the
rear cover from the control console. To remove the cover, use your
fingernails to pry the lower edge loose, then swing the cover up
and out as shown in the following illustration.
Figure 17: Removing the access cover from the P80 console
To thread the cable assembly:
1.
2. Position the console over the console mount.
3. Rest the console on the console mount so that the notch
Assembling and Maintaining TRM 800-Series Treadmills
Make sure that as much of each cable as possible passes
through the opening in the middle of the console mount
on the base unit.
on the bottom of the console's back plate rests on the
rectangular hook at the bottom of the console mount, as
shown in the following figure.
Figure 18: Console positioning on base unit