Treadmill Assembly Guide; Assembly Requirements - Precor 700 Series Assembly Manual

Treadmill Assembly Guide

Follow the steps in the order listed in this assembly guide. For more product
information, visit us at www.precor.com.
WARNING
At least two people are required to assemble the equipment. DO NOT
attempt assembly by yourself.

Assembly requirements

IMPORTANT
Before you fully tighten a fastener, check that its head is flush with the surface of
the equipment. If not, cross-threading may have occurred. DO NOT attempt to
rework the assembly as more damage to the equipment will occur. Instead,
contact Customer Service at www.precor.com.
We recommend you:
• Assemble the equipment close to where you plan to use it.
• Assemble the equipment on a solid, flat surface so that it remains level and
stable.
• Locate the equipment a minimum of 19.7 in. (0.5 m) on each side of the treadmill
and 78 in (2 m) behind the treadmill.
• DO NOT move the equipment without assistance.
Torque measurements
Use the following torque measurements to tighten the fasteners. If a torque is not
provided, then fully tighten the fastener with the appropriate tool.
• Socket head cap screw - 25 ft-lb (33.90 Nm)
• Button head screw - 25 ft-lb (33.90 Nm)
Dash assembly
Heart rate
bar assembly
Arm cover
Bottom arm
cover
Safety key
assembly
Left upright
support
Adjustable foot
Front arm
cover
Right upright
support
Hood
Base side
cover
4