Completing The Console Installation (P80) - Precor TRM 800 Assembling And Maintaining Manual

Installing the Console

Completing the Console Installation (P80)

Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
To complete the installation:
1.
2. Tilt the control console backward (toward yourself) until
3. Insert the four ⁵₈-inch flat head screws through the holes
4. Line up the two small tabs at the top of the console's back
5. Insert the remaining tabs on the back cover with the
6. Press gently on the edges of the back cover to snap it into
Feed extra cable back into the neck tube.
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
in the console mount and thread them into the holes in
the back plate on the console. Partially tighten the screws
using a ⁵₈-inch hex wrench.
cover with the slots at the top of the opening in the
console case. Insert the tabs into the slots.
corresponding slots on the console case.
place.
37