Precor TRM 800 Assembling And Maintaining Manual page 25

Assembling the Treadmill
3. Place the left-hand upright support into the base frame
4. Secure the left-hand upright support to the side bracket
5. Lower the treadmill fairing assembly over the upright
6. Feed the upper end of the cable assembly through the
Component
Television cable
Console power
cable
Auto Stop sensor
cable
Power supply
CAUTION: Be careful not to cut or pinch any wires during the
following step.
side bracket.
using four socket head screws, four black washers, and
two locknuts. Partially tighten the fasteners.
Figure 9: Upright support attachment, left side
supports and align it to them.
Important: In the following step, take care not to unseat any
of the components in the stop switch.
fairing so that its upper end extends through the bottom
opening in the center column and out the round opening
in the console mounting plate.
Appearance
Round with black insulation
Dual leads with red and
black insulation
Round with black insulation
Rectangular, black, 5" x
2¹₄" x 1¹₄"
23
Lower connection
point