Wiring Method To Connector (A To D-Frame) - Panasonic MADDT1207 Technical Reference

3. System Configuration and Wiring

Wiring method to connector (A to D-frame)

• Follow the procedures below for the wiring connection to the Connector CN X1 and X2 .
How to connect
1. Peel off the insulation cover of the cable.
(see the right fig for exact length for peeling.)
2. Insert the cable to the connecter in the following 2 methods.
(a) Using the attached Handle Lever
(b) Using a screw driver (blade width of 3.0 to 3.5 mm)
(a) Using handle lever
Attach the handle lever
to the handling slot on
the upper portion. Press
down the lever to push
down the spring.
* You can pull out the cable by pushing down the spring as the above.
(b) Using screw driver
Press the screw driver
to the handling slot on
the upper portion to
push down the spring.
* You can pull out the cable by pushing down the spring as the above.
<CAUTION>
• Peel off the cable with exact length (8 to 9 mm).
• Take off the connector from the Servo Driver before making connection.
• Insert one cable into each one of cable insertion slot.
• Pay attention to injury by screw driver.
1
Insert the peeled cable
while pressing down the
lever, until it hits the
insertion
hole).
1
Insert the peeled cable
while pressing down the
screw driver, until it hits the
insertion slot (round hole).
– B18 –
2
slot (round
2
8 to 9mm
Release the lever.
Release the screw
driver.
3
3