Bar Code, Expanded Character, Line, Block Drawing & Box Drawing Offset In The X-Axis; Bar Code & Expanded Character Offset In The Y-Axis; Bar Code, Expanded Character, Line, Block Drawing & Box Drawing Height; Expanded Character, Line Block Drawing & Box Drawing Width - Brother HL-1050 Technical Reference Manual

3.7. Bar Code, Expanded Character, Line, Block Drawing & Box Drawing Offset
in the X-axis
n = "xnnn" or "Xnnn"
This parameter specifies the offset from the current print position in the "u"- or "U"-specified units.
3.8. Bar Code & Expanded Character Offset in the Y-axis
n = "ynnn" or "Ynnn"
This parameter specifies the downward offset from the current print position in the "u"- or "U"-specified units.
3.9. Bar Code, Expanded Character, Line, Block Drawing & Box Drawing Height
n = "hnnn", "Hnnn", "dnnn", or "Dnnn"
Default heights
(1) EAN13, EAN8, UPC-A, ISBN (EAN13, EAN8, UPC-A),
ISBN (UPC-E):
(2) UPC-E:
(3) Others:
Expanded characters
Line Block Drawing & Box Drawing
This parameter specifies the height of bar codes or expanded characters as above. It can take the prefix "h",
"H", "d", or "D". The height is specified in the "u"- or "U"-specified units. Note that the default setting of the
bar code height (12 mm, 18 mm or 22 mm) is subject to the bar code mode selected by "t" or "T".
3.10. Expanded Character, Line Block Drawing & Box Drawing Width
n = "wnnn" or "Wnnn"
Default widths
Expanded character
Line Block Drawing & Box Drawing
This parameter specifies the width of expanded characters in the selected units as above.

3.11. Expanded Character Rotation

n = "a0" or "A0"
n = "a1" or "A1"
n = "a2" or "A2"
n = "a3" or "A3"
Upright (default)
Rotated 90 degrees clockwise
Upside down, rotated 180 degrees clockwise
Rotated 270 degrees clockwise
CHAPTER 8 BAR CODE CONTROL - 7
22 mm
18 mm
12 mm
2.2 mm (default)
1 dot
1.2 mm
1 dot
99/08/03