Brother HL-1050 Technical Reference Manual page 251

Hide thumbs Also See for HL-1050:
Table of Contents

Advertisement

Set data MSB to 1
Esc>
(27)(62)
• This command enables you to set the most significant bit of incoming data bytes to 1.
• This command does not affect data comprising a graphics image or data that defines a downloadable
character.
LPRINT CHR$(27); CHR$(62); 'Set MSB to 1
Cancel MSB setting
Esc#
(27)(35)
This command cancels the two commands that set the most significant bit of incoming data bytes (Esc =
and Esc >).
LPRINT CHR$(27); CHR$(35); 'Cancel MSB setting
Select Near Letter Quality or Draft
Escxn
(27)(120)n
The printer ignores this command.
Select / cancel half speed mode
Escsn
(27)(115)n
The printer ignores this command.
Enable printer
DC1
(17)
The printer ignores this command.
Disable printer
DC3
(19)
The printer ignores this command.
Initialize printer
Esc@
(27)(64)
• This command resets the printer.
• All remaining data is printed out and the printer default settings are restored.
LPRINT CHR$(27); CHR$(64); 'Printer reset
Reset printer / change emulation mode
EscCR<mode>
(27)(13)mode
• This command enables you to switch emulation mode or to reset the printer.
• Change emulation mode by setting mode to the appropriate letter or pair of letters. Set mode to 'D' to
switch to Diablo mode, 'H' to switch to LaserJet mode, 'I' to switch to IBM Proprinter XL mode,
'AB' to switch to BR-Script Batch mode, 'AI' to switch BR-Script Interactive mode, 'GL' to switch to
HP-GL mode.
• If you set mode to 'E' in Epson FX-850 mode , a printer reset is performed.
• If you set mode to 'FD', to reset the printer to its factory default settings, LaserJet mode (the factory
default emulation mode) is selected and the LaserJet factory default environment is restored. For a
list of the factory default settings see the sub-section "Factory default environment" in Chapter 2
"PCL" of this manual.
• On receiving this command the printer prints any remaining data and performs a page eject (unless
the current page is blank). The newly selected emulation mode's default settings come into effect,
except when mode is set to 'FD'.
LPRINT CHR$(27); CHR$(13); CHR$(73); 'Change to IBM Proprinter mode
<1Bh><3Eh>
<1Bh><23h>
<1Bh><78h>n
<1Bh><73h>n
<11h>
<13h>
<1Bh><40h>
<1Bh><0Dh>mode
CHAPTER 6 EPSON - 11
99/08/03

Advertisement

Table of Contents
loading

Table of Contents