Autosleep; Powersave; Timeoutsleep; Envinterval - Brother HL-1050 Technical Reference Manual

99/08/03
2.7.7.
Command
@PJL SET AUTOSLEEP=parameter<LF>
@PJL DEFAULT AUTOSLEEP=parameter<LF>
(parameter)
ON:
OFF:
Explanation
This command sets the power save mode. The setting will be valid immediately after changing. (Same as

POWERSAVE)

2.7.8.
Command
@PJL SET POWERSAVE=parameter<LF>
@PJL DEFAUTLPOWERSAVE=parameter<LF>
(parameter)
ON:
OFF:
Explanation
This command sets the power save mode. The setting will be valid immediately after changing. (Same as

AUTOSLEEP)

2.7.9.
Command
@PJL SET TIMEOUTSLEEP=parameter<LF>
@PJL DEFAULT TIMEOUTSLEEP=parameter<LF>
(parameter)
1 - 99
2.7.10. RAS1200MODE (For HL-1050/1070/1250/1270N only)
Command
@PJL SET RAS1200MODE=parameter<LF>
@PJL DEFAULT RAS1200MODE=parameter<LF>
(parameter)
OFF:
ON:
Explanation
This command prints raster graphics at 1200 dpi. This setting is not stored in the NV-RAM.

2.7.11. ENVINTERVAL

Command
@PJL SET ENVINTERVAL=parameter<LF>
@PJL DEFAULT ENVINTERVAL=parameter<LF>
(parameter)
0 - 255 sec. (Default = 0 = 12 sec.)
APPENDIX D REFERENCE LIST OF HL-1050/1070/1250/1270N/P2500 PJL COMMANDS - 12
AUTOSLEEP
Valid POWER SAVE MODE
Invalid POWER SAVE MODE
POWERSAVE
Valid POWER SAVE MODE
Invalid POWER SAVE MODE

TIMEOUTSLEEP

(Default 5 min.)
Default
Use 1200 dpi for raster graphics