Box Drawing; Line Block Drawing; Expanded Character Data Start - Brother HL-4150CDN User Manual

Appendix
When Code 128 Set A, Set B, or Set C is selected with the parameter 't12' or 'T12', 't13' or 'T13', or 't14'

or 'T14'
Code 128 sets A, B and C can be individually selected. Set A shows characters Hex 00 to 5F. Set B
includes characters Hex 20 to 7F. Set C includes the pairs 00 to 99. Switching is allowed between the code
sets by sending %A, %B, or %C. FNC 1, 2, 3, and 4 are produced with %1, %2, %3, and %4. The SHIFT
code, %S, allows temporary switching (for one character only) from set A to set B and vice versa. The '%'
character can be encoded by sending it twice.
 When ISBN (EAN) is selected with the parameter 't130' or 'T130'
The same rules apply as for 't5' or 'T5'.
 When ISBN (UPC-E) is selected with the parameter 't131' or 'T131':
The same rules apply as for 't6' or 'T6'.
 When EAN 128 set A, set B or set C is selected with the parameter 't132' or 'T132', 't133' or 'T133' or 't134'
or 'T134'
The same rules apply as for 't12' or 'T12', 't13' or 'T13', or 't14' or 'T14'.

Box drawing

ESC i ... E (or e)
'E' or 'e' is a terminator.

Line block drawing

ESC i ... V (or v)
'V' or 'v' is a terminator.

Expanded character data start

n = 'l' or 'L'
Data that follows 'l' or 'L' is read as expanded character data (or labeling data). Expanded character data must
end with the ' \ ' code (5CH), which also ends this command.
Table of Code(EAN) 128 set C
Code(EAN) 128 set C describes an original command. The correspondence table is as follows.
A
A
A
A
A
186