Operating instructions dish-washing machine model M-iQ
Datei:BA_B-M-iQ_9675717_EN_2010-01.docx
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
14
Tips for self-help in the case of faults
Fault:
Machine does not fill.
Rinse water does not
spray!
Vapours drains!
Stripes and smears on the
dishes!
Formation of a significant
amount of foam in the
wash tank!
W e reserv e the right to change execution and construction!
Remedy
No water available
Dirt trap blocked
Level electrode / float valve soiled
Solenoid valve defective
No water available
Dirt trap blocked
Solenoid valve defective
If the appliance has automatic water conservation, the
conservation grid switch / timing switch is defective
Pump for pumping water from the machine cistern
broken down
Fresh water rinse system furred
Built-in reverse osmosis installation broke down
Extraction broke down
Curtains missing
Temperatures too high
Wash arms, drying nozzles, air guide plates bent or
not correctly inserted
Rinse water mineral content too high (see operating
instructions)
If this is observed only at particular times, check water
softener for regeneration. This must not carried out
during the dishwashing operation.
Water pre-treatment defective or not carried out
Different water type depending on the waterworks
Unsuitable rinse aid products or wrong dosage
quantity
Incorrectly fitted or missing curtains
Oversize containers previously washed causing
detergent to be transferred into following tanks.
Too fast conveyor speed
Detergent for dish-washing by hand enters the wash
tank because of pre-cleaning the dishes
Daily cleaning of the machine is carried out with
foaming cleansing agents which afterwards enter the
machine.
Improve pre-wash, as too much food residue is
entering the tanks Alternatively, empty wash tanks
between uses.
Rinse water quantity too low
Detergent or rinse aid product not suitable
Temperatures too low < 40°C
44/52