Usage - Honda Miimo HRM1000 Owner's Manual

Configuring the settings through the setup wizard
This section explains the setup wizard procedure using the control panel on the lawnmower.
The setup wizard will guide you to configure the settings for your mowing operation as follows:
Menu name
[1.Garden layout]
[2.Start points]
[3.Test start points]
[4.Work timer]
NOTE:
- Before starting the setup wizard, confirm the completion of installing the docking station and laying
boundary wire with your dealer.
- Before starting the setup wizard, fill out the DEALER CHECKSHEET at the end of the Owner's Manual.
- If the DEALER CHECKSHEET at the end of Owner's Manual was already filled out by your dealer, refer
to it when configuring the settings through the setup wizard.
- After the settings are finished through the setup wizard, you can modify the setting values in the menu
settings. For details, see "4. MENU SETTINGS" (M page 44).
- You can also modify the setting values in Mii-monitor.

Usage

For configuring the settings related to
the layout of the boundary wire. These
setting values are referred from the
other settings.
For configuring the mowing start point
settings to enable the lawnmower to
start mowing from other areas than
from docking station.
For testing the start points configured
in [2.Start points] menu.
For setting the work timer to operate
the lawnmower according to the
schedule.
Setting up the lawnmower
Configuring and testing the
settings
- Signal type
- Quantity of the shortcut wire
- Direction for the lawnmower to dock to
the docking station
- Length of the boundary wire
- Garden size
- Direction of the mowing start points
- Distance of the start points from the
docking station
- Ratio with which the lawnmower
operates in each area
- Testing the setting of each start point
- Work day and work time
- Seasonal work time
31