Cisco AIR-PCM341 Installation And Configuration Manual page 147

Appendix F Performing a Site Survey
Table F-2
Parameter
Tx Type
After setting any parameters, tap OK to save your settings. The Site Survey - Passive screen appears (see
Step 2
Figure
Tap the Start button to run the site survey test. The Site Survey - Active screen appears.
Step 3
Figure F-5
percentages, and
Figure F-5
OL-1375-03
Site Survey Active Mode Parameters (continued)
Description
The packet type that is transmitted during the test.
Default: Unicast
Packet Type
Unicast
Multicast
F-2).
shows the Site Survey - Active screen with the signal strength values displayed as
Figure F-6 shows the same screen with the signal strength values displayed in dBm.
Site Survey - Active Screen (with Signal Strength as a Percentage)
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Using Active Mode
Description
When unicast packets are used, the system
expects to receive an acknowledgment
from the destination, and retries can occur.
When multicast packets are used, no
packet retries occur during the test.
F-9