Cisco AIR-PCM341 Installation And Configuration Manual page 146

Using Active Mode
Table F-2
Parameter
Number of Packets
Data Rate
Continuous Link Test
Packet Size
Delay Between Packets
Percent Success Threshold
Data Retries
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
F-8
Site Survey Active Mode Parameters (continued)
Description
The number of packets that will be sent during the test.
Range: 1 to 999
Default: 100
The bit rate at which packets are transmitted. Rate shifting does not
occur during the test because the echo test built into the radio firmware
does not support it
Value: 1, 2, 5.5, or 11 Mbps
Default: 11 Mbps
Checking this check box causes the test to run until you tap OK or
Stop. The test loops repeatedly for the number of packets specified in
the Number of Packets field.
Default: Unchecked
The size of the packets that are sent during the test. Select a size that is
typical during normal system use.
Range: 30 to 1450
Default: 512
The delay (in milliseconds) between successive transmissions.
Range: 1 to 2048 ms
Default: 1 ms
The percentage of packets that are not lost.
This parameter controls the red line on the Percent Successful
histogram. Percentages greater than or equal to this value are displayed
as green bars; percentages below this value are displayed as yellow
bars.
Range: 0 to 100%
Default: 75
The number of times a transmission is retried if an acknowledgment
(Ack) is not returned by the destination device.
Default: None
Retry Value
None
Default Retries
Appendix F Performing a Site Survey
Description
No retries will occur.
The firmware's default value for retries
(16) will be used.
OL-1375-03