Using PEAP
Using PEAP
After Profile Selection, Card Insertion, or Reset
After you select a profile that uses host-based EAP authentication and configure the card for PEAP,
follow the steps below to EAP authenticate.
These instructions are applicable for use with Windows NT or 2000 domain, LDAP, or OTP user
Note
databases after profile selection, card ejection and reinsertion, or reset.
If a message appears informing you that you need to select a certificate or other credentials to access the
Step 1
network, tap this message.
If a message appears indicating the root certification authority for the server's certificate and it is the
Step 2
correct certification authority, tap OK to accept the connection. Otherwise, tap Cancel.
If a message appears indicating the server to which your client adapter is connected and it is the correct
Step 3
server to connect to, tap OK to accept the connection. Otherwise, tap Cancel.
The Static Password screen appears (see
Step 4
Note
Figure 6-3
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
6-6
If a message appears prompting you to process your logon information for your wireless
network, tap this message. Then the Static Password screen appears.
Static Password Screen
Figure
6-3).
Chapter 6
Using EAP Authentication
OL-1375-03