Disabling Static Wep; Using Leap; Enabling Leap - Cisco AIR-PCM341 Installation And Configuration Manual

Using LEAP

Step 5 Make sure the Transmit Key button to the left of your key is selected, if you want this key to be used to
transmit packets.
Step 6 Tap OK to write your new static WEP key to the client adapter's volatile memory and the registry of the
Windows CE device or tap Cancel to exit the WEP Keys screen without overwriting any keys.
Step 7 Tap OK to save your changes.

Disabling Static WEP

Follow the steps below if you ever need to disable static WEP.
Selecting LEAP for the Network Security Type disables static WEP automatically.
Note
Double-tap the ACU icon or select Start > Programs > Cisco > ACU. The Profiles screen appears.
Step 1
Step 2 Select the profile that you want to change from the Manage Profiles box and tap the Edit button.
Step 3 Select WEP under Property and No WEP from the list of options in the Value box.
Step 4 Tap OK to save your changes.

Using LEAP

Before you can enable LEAP authentication, your network devices must meet the following
requirements:
•
•
•

Enabling LEAP

Follow the steps below to enable LEAP authentication for this profile.
Step 1 From the Properties screen, select Network Security Type under Property and LEAP from the list of
options in the Value box. When LEAP is enabled, the following parameters on the Properties screen are
changed automatically:
•
•
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
5-16
Client adapters must support WEP, and firmware version 5.02.19 or greater is recommended.
Access points to which your client adapter will attempt to authenticate must use the following
firmware versions or greater: 11.23T (340 and 350 series access points), 12.2(4)JA (1100 series
access points), or 11.54T (1200 series access points).
All necessary infrastructure devices (for example, access points, servers, etc.) must be properly
configured for LEAP authentication.
WEP is set to Dynamic WEP Keys.
Authentication Type is set to Open.
Chapter 5 Configuring the Client Adapter
OL-1375-03