Cisco AIR-PCM341 Installation And Configuration Manual page 145

Appendix F Performing a Site Survey
Figure F-4
Table F-2
instructions in the table to set any parameters.
Table F-2
Parameter
Destination MAC Address
Destination Is Another Cisco
Aironet Device
OL-1375-03
Active Mode Setup Screen
lists and describes the parameters that affect how the site survey is performed. Follow the
Site Survey Active Mode Parameters
Description
The MAC address of the access point (in infrastructure mode) or other
clients (in ad hoc mode) that will be used in the test.
Default: The MAC address of the access point (in infrastructure mode)
Note
Checking this check box indicates that the device you named in the
Destination MAC Address field is a Cisco Aironet access point (in
infrastructure mode) or client (in ad hoc mode). In this case, packets sent
to the client from the Cisco Aironet device contain additional information,
such as lost to source, lost to target, and percent retries, and this
information is displayed in the Site Survey - Active screen.
If the device specified in the Destination MAC Address field is not a
Cisco Aironet device, do not check this check box. In this case, the test
sends out loopback packets, which originate from and return to the
client adapter.
Default: Checked
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
to which your client adapter is associated
During the test, the client adapter does not roam to other access
points so that the size of a single cell can be determined.
Using Active Mode
F-7