Synchronizing Security Features - Cisco AIR-PCM341 Installation And Configuration Manual

Chapter 5 Configuring the Client Adapter

Synchronizing Security Features

In order to use any of the security features discussed in this section, both your client adapter and the access
point to which it will associate must be set appropriately.
settings required for each security feature. This chapter provides specific instructions for enabling the security
features on your client adapter. Refer to the software configuration guide for your access point for
instructions on enabling any of these features on the access point.
Table 5-2
Security Feature
Static WEP with open
authentication
Static WEP with shared key
authentication
LEAP authentication
EAP-TLS authentication
PEAP authentication
MIC
TKIP
Broadcast key rotation
OL-1375-03
Client and Access Point Security Settings
Client Setting
Create a WEP key and enable Static
WEP Keys and Open
Authentication
Create a WEP key and enable Static
WEP Keys and Shared Key
Authentication
Enable LEAP
Enable Host Based EAP and
Dynamic WEP Keys in ACU and
select TLS as the EAP Type in the
Authentication Manager
Enable Host Based EAP and
Dynamic WEP Keys in ACU and
select Cisco PEAP (or PEAP) as
the EAP Type in the Authentication
Manager
Use driver version 2.30 or greater
Use firmware version 5.02.19 or
greater
Use firmware version 5.02.19 or
greater and enable LEAP,
EAP-TLS, or PEAP
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Overview of Security Features
Table 5-2 indicates the client and access point
Access Point Setting
Set up and enable WEP and enable
Open Authentication
Set up and enable WEP and enable
Shared Key Authentication
Set up and enable WEP and enable
Network-EAP
Set up and enable WEP and enable
Network-EAP
Set up and enable WEP and enable
Network-EAP
Set up and enable WEP with full
encryption, set MIC to MMH, and
set Use Aironet Extensions to Yes
Set up and enable WEP, set TKIP to
Cisco, and set Use Aironet
Extensions to Yes
Set up and enable WEP and set
Broadcast WEP Key Rotation
Interval to any value other than
zero (0)
5-13