Fujitsu ETERNUS DX600 S3 Basic Operation Manual page 47

Chapter 2 Basic Operation
2.2 Powering On and Off
After turning the power on, it takes approximately three minutes (approximately six minutes in a Uni-
•
fied configuration) for the ETERNUS DX to become READY (i.e. the READY LED turns on). If an error is
detected in a component during the initial power-on diagnostics, it may take up to ten minutes for the
ETERNUS DX to be in READY state. This should be taken into consideration for scheduled operations.
Before turning the server on, check that the ETERNUS DX and the network devices that connect the
•
ETERNUS DX and the server are all in READY status.
If the server is turned on while any of these devices are not in READY status, the server may not be able
to recognize the ETERNUS DX.
To turn on the ETERNUS DX by linking with the server, the server must wait until the ETERNUS DX is in a
•
READY state.
If the Auto Power function is enabled via ETERNUS Web GUI or ETERNUS CLI, the ETERNUS DX is automat-
•
ically turned on when power is supplied to the ETERNUS DX.
If the Power Resume function is enabled via ETERNUS Web GUI or ETERNUS CLI, the ETERNUS DX is auto-
•
matically turned on after the power is restored.
If the REMOTE LED of the ETERNUS DX is green, turn on the ETERNUS DX via a power synchronized unit.
•
After power-off, wait for about one minute before turning power on again.
•
This section explains how to use the Power switch to turn on the ETERNUS DX.
For other procedures, refer to the related manuals.
1
Press the Power switch of the controller enclosure.
Power switch
The POWER LEDs on the controller enclosure and the drive enclosures are turned on.
2
After approximately three minutes (after approximately six minutes in a Unified configuration), check
that the READY LED of the controller enclosure is lit up.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Controller enclosure
Drive enclosure
Controller enclosure
47
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0