Powering Off - Fujitsu ETERNUS DX600 S3 Basic Operation Manual

Chapter 2 Basic Operation
2.2 Powering On and Off
2.2.4

Powering Off

To turn off the ETERNUS DX, perform one of the procedures below.
• Via power switch
Press the Power switch to turn off the ETERNUS DX.
Via ETERNUS Web GUI or ETERNUS CLI
•
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS DX.
The following methods can be used to turn off the power by linking with the server.
• Via the power synchronized unit
Use the power synchronized unit to turn off the ETERNUS DX.
When turning off the ETERNUS DX, the power shuts off after the write data in the cache memory is writ-
•
ten back to the drives. As a result, it may take approximately one to seven minutes (approximately
three to seven minutes in a Unified configuration) for the power supply to be completely turned off.
Do not turn off the power of the ETERNUS DX and the network devices that connect the ETERNUS DX to a
•
server while the server is operating. This may result in the loss of data or prevent data from being saved
in the ETERNUS DX.
• When using a power synchronized unit for power control, turn off the power of the ETERNUS DX via the
power synchronized unit. When a power synchronized unit is connected, the power of the ETERNUS DX is
automatically turned on because the power synchronization function is activated.
• If the REMOTE LED on the ETERNUS DX is green, turn off the ETERNUS DX by linking with the server.
Pressing the Power switch does not turn off the ETERNUS DX.
• To turn off the ETERNUS DX, use the Power switch, a power synchronized unit, ETERNUS Web GUI, or
ETERNUS CLI. If any other method is used to turn off the ETERNUS DX, the replacement time for a battery
is sped up significantly because the battery continues to charge and discharge.
After power-off, wait for about one minute before turning power on again.
•
This section explains how to use the Power switch to turn off the ETERNUS DX.
For other procedures, refer to the related manuals.
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
Power switch
The READY LED on the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Controller enclosure
48
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0