Table of Contents
Advertisement
A
F
PPENDIX
R
F
ESTORING
To restore the Bluetooth CRS to its factory defaults, do the following:
1. Turn on the assembled Bluetooth CRS – the ring scanner must be
attached.
2. Press and hold both the left and right trigger buttons.
3. While still pressing the left and right trigger buttons, briefly press
and release the power button on the wrist unit.
4. Wait 15 seconds or until you hear a single beep.
5. Release both trigger buttons at the same time. If you performed
the actions correctly, multiple beeps will sound. The Bluetooth
CRS will power off.
6. The next time you power on the Bluetooth CRS, it will reset the
virtual memory and scan engine to their factory default settings.
78
D
ACTORY
EFAULTS
Advertisement
Table of Contents
