Step 9: Scan Data Into Your Application - Socket 9M User Manual

STEP 9: S D
CAN
Press the trigger button and aim your finger at the bar code. The red
laser beam should cover the entire width of the bar code.
After a successful scan, the Bluetooth CRS will beep, the LED will
flash green, laser will turn off, and data will appear in your
application. By default, the cursor automatically advances to the next
cell or line, ready for the next scan.
Notes:
•
See Appendix B for scanning tips.
•
If no data is read in a few seconds, the laser will turn off, and you must
try again.
SocketScan Auto-Reconnect
If your mobile device suspends or the Bluetooth CRS moves out of
range, the connection will end. After the mobile device turns on
again or the Bluetooth CRS returns into range, SocketScan will try to
re-connect for about 3 minutes.
If, after 3 minutes, they have not re-connected, manually re-connect
them by tapping on the SocketScan icon and tapping Connect CS.
26
Y A
ATA INTO OUR PPLICATION