Factory Reset - Socket SocketScan 700 Series User Manual

Configures the scanner to factory defaults. The scanner powers off
after scanning this barcode.
Or, follow the Factory Reset button sequence:
1. Power ON the scanner.
2. Press and hold the scan button.
3. Tap the power button once while continuing to press the scan
button.
4. Keep holding the trigger button until you hear a beep
(about15 seconds).
When you release the scan button you will hear 5 confirmation beeps
then the scanner will power off.
Note: If you follow this sequence but release the trigger button too
early (before 15 seconds and the beep) the Factory Reset will fail.

Factory Reset

Quickly press and release
the power button
1
2
26