Factory Reset - Socket SocketScan 700 Series User Manual

Configures the barcode reader to factory defaults. The barcode reader powers
off after scanning this barcode.
Or, follow the Factory Reset button sequence:
1. Power ON the barcode reader.
2. Press and hold the scan button.
3. Tap the power button once while continuing to press the scan button.
4. Keep holding the trigger button until you hear a beep (about 15 seconds).
When you release the scan button you will hear 5 confirmation beeps then the
barcode reader will power off.
Note: If you follow this sequence but release the trigger button too early
(before 15 seconds and the beep) the Factory Reset will fail.

Factory Reset

1
2
25
Quickly press and release
the power button