Step 11: Scan Data Into Your Application - Socket 9M User Manual

STEP 11: S D
CAN
1. Press the trigger button and aim your finger at the bar code. The
red laser beam should cover the entire width of the bar code.
Note: When data is read and sent to the computer, the laser will turn off.
Depending on your scanner settings, the scanner may beep and/or the
ring scanner's LED may flash green to indicate a good read.
Note: If no data is read in a few seconds, the laser will turn off, and you
must try again.
Note: See Appendix B for scanning tips.
2. After a successful scan, data should appear in your document. By
default, the cursor automatically advances to the next cell or line,
ready for data from the next scan.
Note: Wait for the "Good Scan" indication before you scan another bar
code. If you try to scan too fast, the device can lock up until you stop
scanning.
CHAPTER 4: SETUP FOR WINDOWS XP & WINDOWS VISTA
Y A
ATA INTO OUR PPLICATION
49