INSTRUCTIONS: Scan command barcode(s) to quickly configure the barcode scanner.
Make sure the scanner is not connected to a host computer or device before scanning a
command barcode!
To use the scanner on multiple hosts, perform the unpair sequence.
1. Power on the scanner.
2. Press and hold down the trigger button.
3. Press and hold down the power button.
4. After you hear 3 beeps, release both buttons.
*NOTE: You may have to "Forget" or "Delete" the pairing on your host device, as well.
By default, the scanner is in Basic Mode (HID) as a Keyboard device.
For scanners in Application Mode (SPP) or Application Mode (MFi-SPP), you can alternatively config-
ure some settings by using the Scanner Settings app. You can download the app from iTunes, and
Play.
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS powers off after scanning this bar-
code.
FACTORY DEFAULTS
#FNB00F0#
Google
3