Preset From Outside Of Circle (Cycle 413, Din/Iso: G413, Software Option 17); Cycle Run - HEIDENHAIN TNC 620 User Manual

Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413,
software option 17)
14.7 PRESET FROM OUTSIDE OF CIRCLE
(Cycle 413, DIN/ISO: G413, software
option 17)

Cycle run

Touch Probe Cycle 413 finds the center of a circular stud and
defines it as preset. If desired, the TNC can also enter the
coordinates into a datum table or the preset table.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", Page 339) to touch point 1. The
TNC calculates the touch points from the data in the cycle and
the safety clearance from the SET_UP column of the touch
probe table.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column F). The TNC derives the probing direction automatically
from the programmed starting angle.
3 Then the touch probe moves in a circular arc either at measuring
height or at clearance height to the next starting point
probes the second touch point.
4 The TNC positions the probe to starting point
starting point to probe the third and fourth touch points.
4
5 Finally the TNC returns the touch probe to the clearance height
and processes the determined preset depending on the cycle
parameters Q303 and Q305 (see "Characteristics common to
all touch probe cycles for presetting", Page 370) and saves the
actual values in the Q parameters listed below.
6 If desired, the TNC subsequently measures the preset in the
touch probe axis in a separate probing.
Parameter number
Q151
Q152
Q153
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
3 and then to
Meaning
Actual value of center in reference axis
Actual value of center in minor axis
Actual value of diameter
and
2
14
393