Kinematics Measurement With Ts Touch Probes (Kinematicsopt Option); Fundamentals; Overview - HEIDENHAIN TNC 620 User Manual

17
Touch Probe Cycles: Automatic Kinematics Measurement | Kinematics measurement with TS touch probes
17.1 Kinematics measurement with TS touch
probes (KinematicsOpt option)

Fundamentals

Accuracy requirements are becoming increasingly stringent,
particularly in the area of 5-axis machining. Complex parts need to
be manufactured with precision and reproducible accuracy even
over long periods.
Some of the reasons for inaccuracy in multi-axis machining are
deviations between the kinematic model saved in the control
(see 1 in the figure at right), and the kinematic conditions actually
existing on the machine (see
rotary axes are positioned, these deviations cause inaccuracy of
the workpiece (see
for the model to approach reality as closely as possible.
The TNC function
that helps you to really fulfill these complex requirements: a 3-D
touch probe cycle measures the rotary axes on your machine fully
automatically, regardless of whether they are in the form of tables
or spindle heads. A calibration sphere is fixed at any position on
the machine table, and measured with a resolution that you define.
During cycle definition you simply define for each rotary axis the
area that you want to measure.
From the measured values, the TNC calculates the static tilting
accuracy. The software minimizes the positioning error arising
from the tilting movements and, at the end of the measurement
process, automatically saves the machine geometry in the
respective machine constants of the kinematic table.

Overview

The TNC offers cycles that enable you to automatically save, check
and optimize the machine kinematics:
Soft key Cycle
450 SAVE KINEMATICS
Automatic saving and restoring of
kinematic configurations
451 MEASURE KINEMATICS
Automatic checking or optimizing the
machine kinematics
452 PRESET COMPENSATION
Automatic checking or optimizing the
machine kinematics
490
2 in the figure at right). When the
in the figure at right). It is therefore necessary
3
is an important component
KinematicsOpt
Page
493
496
510
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
(KinematicsOpt option)