Dwell Time (Cycle 9, Din/Iso: G04); Function; Cycle Parameters - HEIDENHAIN TNC 620 User Manual

Cycles: Special Functions | DWELL TIME (Cycle 9, DIN/ISO: G04)

11.2 DWELL TIME (Cycle 9, DIN/ISO: G04)

Function

This causes the execution of the next block within a running program
to be delayed by the programmed DWELL TIME. A dwell time can be
used for such purposes as chip breaking.
The cycle becomes effective as soon as it is defined in the program.
Modal conditions such as spindle rotation are not affected.

Cycle parameters

Dwell time in seconds: Enter the dwell time
in seconds. Input range: 0 to 3600 s (1 hour) in
steps of 0.001 seconds
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
NC blocks
89 CYCL DEF 9.0 DWELL TIME
90 CYCL DEF 9.1 DWELL 1.5
11
311