Tapping With Chip Breaking (Cycle 209, Din/Iso: G209, Software Option 19); Cycle Run - HEIDENHAIN TNC 620 User Manual

4
Fixed Cycles: Tapping / Thread Milling | TAPPING WITH CHIP BREAKING (Cycle 209, DIN/ISO: G209, software
4.4 TAPPING WITH CHIP BREAKING (Cycle
209, DIN/ISO: G209, software option 19)

Cycle run

The TNC machines the thread in several passes until it reaches the
programmed depth. You can define in a parameter whether the tool
is to be retracted completely from the hole for chip breaking.
1 The TNC positions the tool in the tool axis at rapid traverse
FMAX to the programmed set-up clearance above the workpiece
surface. There it carries out an oriented spindle stop.
2 The tool moves to the programmed infeed depth, reverses the
direction of spindle rotation and retracts by a specific distance
or completely for chip release, depending on the definition. If
you have defined a factor for increasing the spindle speed, the
TNC retracts from the hole at the corresponding speed.
3 It then reverses the direction of spindle rotation again and
advances to the next infeed depth.
4 The TNC repeats this process (2 to 3) until the programmed
thread depth is reached.
5 The tool is then retracted to set-up clearance. If programmed,
the tool moves to the 2nd set-up clearance at FMAX.
6 The TNC stops the spindle turning at set-up clearance.
122
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
option 19)