Preset From Outside Of Rectangle (Cycle 411, Din/Iso: G411, Software Option 17); Cycle Run - HEIDENHAIN TNC 620 User Manual

14
Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF RECTANGLE (Cycle 411,
14.5 PRESET FROM OUTSIDE OF
RECTANGLE (Cycle 411, DIN/ISO: G411,
software option 17)

Cycle run

Touch Probe Cycle 411 finds the center of a rectangular stud and
defines its center as preset. If desired, the TNC can also enter the
coordinates into a datum table or the preset table.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", Page 339) to touch point 1. The
TNC calculates the touch points from the data in the cycle and
the safety clearance from the SET_UP column of the touch
probe table.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column F).
3 Then the touch probe moves either paraxially at measuring
height or at clearance height to the next starting point
probes the second touch point.
4 The TNC positions the probe to starting point
starting point 4
5 Finally the TNC returns the touch probe to the clearance height
and processes the determined preset depending on the cycle
parameters Q303 and Q305 (see "Characteristics common to all
touch probe cycles for presetting", Page 370).
6 If desired, the TNC subsequently measures the preset in the
touch probe axis in a separate probing and saves the actual
values in the following Q parameters.
Parameter number
Q151
Q152
Q154
Q155
384
to probe the third and fourth touch points.
Meaning
Actual value of center in reference axis
Actual value of center in minor axis
Actual value of length in the reference
axis
Actual value of length in the minor axis
2 and
3 and then to
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
DIN/ISO: G411, software option 17)