HEIDENHAIN TNC 620 User Manual page 379

Touch Probe Cycles: Automatic Presetting | RIDGE CENTER PRESET (Cycle 409, DIN/ISO: G409, software
option 17)
Q405 New preset? (absolute): Coordinate in the
measuring axis at which the TNC should set the
calculated ridge center. Default setting = 0. Input
range -99999.9999 to 99999.9999
Q303 Meas. value transfer (0,1)?: Specify if the
determined basic rotation is to be saved in the
datum table or in the preset table:
0: Write the measured basic rotation as datum
shift in the active datum table. The reference
system is the active workpiece coordinate system
1: Write the measured basic rotation into the
preset table. The reference system is the machine
coordinate system (REF system).
Q381 Probe in TS axis? (0/1): Specify whether
the TNC should also set the preset in the touch
probe axis:
0: Do not set the preset in the touch probe axis
1: Set the preset in the touch probe axis
Q382 Probe TS axis: Coord. 1st axis? (absolute):
Coordinate of the probe point in the reference axis
of the working plane at which point the preset is
to be set in the touch probe axis. Only effective if
Q381 = 1. Input range -99999.9999 to 99999.9999
Q383 Probe TS axis: Coord. 2nd axis? (absolute):
Coordinate of the probe point in the minor axis
of the working plane at which point the preset is
to be set in the touch probe axis. Only effective if
Q381 = 1. Input range -99999.9999 to 99999.9999
Q384 Probe TS axis: Coord. 3rd axis? (absolute):
Coordinate of the probe point in the touch probe
axis, at which point the preset is to be set in the
touch probe axis. Only effective if Q381 = 1. Input
range -99999.9999 to 99999.9999
Q333 New preset in TS axis? (absolute):
Coordinate in the touch probe axis at which the
TNC should set the preset. Default setting = 0.
Input range -99999.9999 to 99999.9999
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
Q381=1 ;PROBE IN TS AXIS
Q382=+85 ;1ST CO. FOR TS AXIS
Q383=+50 ;2ND CO. FOR TS AXIS
Q384=+0 ;3RD CO. FOR TS AXIS
Q333=+1 ;PRESET
14
379