Table of Contents
Advertisement
PART A – INSTALLATION
2 INSTALLATION SAFETY INFORMATION
2.1 Warnings and Cautions
THE INFORMATION GIVEN ON THE CERTIFICATION LABEL AFFIXED TO THE STOVE ALWAYS
OVERRIDES THE INFORMATION PUBLISHED IN ANY OTHER MEDIA (OWNER'S MANUAL,
CATALOGUES, FLYERS, MAGAZINES AND/OR WEB SITES).
• IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK
OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS.
•
BURNING ANY SOLID FUELS GENERATES CARBON MONOXIDE IN LOW CONCENTRATION. THIS
GAS IS EVACUATED BY THE EXHAUST VENTING SYSTEM. IN HIGHER CONCENTRATIONS,
CARBON MONOXIDE IS TOXIC AND MAY CAUSE DEATH. TO PREVENT THIS, ENSURE THAT
YOUR EXHAUST VENTING SYSTEM IS AIRTIGHT.
• WHEN LOCATING YOUR APPLIANCE, MAKE SURE THE VENT WILL NOT INTERFERE WITH ANY
TRUSS, ROOF BEAMS, WALL STUDS, WATER PIPES OR ELECTRICAL WIRING. IT MAY BE EASIER
TO RELOCATE APPLIANCE THAN TO REWORK THE BUILDING STRUCTURE.
•
THIS STOVE IS NOT RECOMMENDED TO BE INSTALLED IN A BEDROOM.
• CONNECT THIS STOVE ONLY TO A LISTED PELLET EXHAUST VENTING SYSTEM FOR USE WITH
SOLID FUEL OR TO A LINED CHIMNEY CONFORMING TO NATIONAL AND LOCAL BUILDING
CODES.
• DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.
• DO NOT CONNECT THIS STOVE TO ANY OTHER EXISTING VENTING SYSTEM SERVING ANOTHER
APPLIANCE.
• DO NOT CONNECT TO OR USE IN CONJUNCTION WITH ANY AIR DISTRIBUTION DUCTWORK.
• THE VENTING SYSTEM MUST BE COMPLETELY AIRTIGHT AND PROPERLY INSTALLED. ALL VENT
CONNECTOR JOINTS MUST BE SEALED AND FASTENED IN ACCORDANCE WITH THE PELLET
VENT MANUFACTURER'S INSTRUCTIONS TO ENSURE CONSISTENT PERFORMANCE AND AVOID
SMOKE AND ASH SPILLAGE.
•
THE VENTING SYSTEM SHOULD BE CHECKED, AT LEAST TWICE A YEAR FOR ANY BUILDUP OF
SOOT OR CREOSOTE.
Cambridge Pellet Stove Installation and Operation Manual
ATTENTION
CAUTION
WARNING – APPLIANCE LOCATION
WARNING – VENTING SYSTEM
9
Advertisement
Table of Contents
