Table of Contents
Advertisement
8.1.4 Cleaning the Burn Pot
The burn pot must remain clean and the holes should not be obstructed by combustion residues
(ashes or clinkers).
1. Clean the burn pot using a scraper.
2. The burn pot simply sits onto the air intake channel. You must lift to remove it from the stove.
Two small pins guide the burn pot in place. Make sure that the burn pot is well in place before
turning on the stove (as shown in the diagram).
3. If necessary, clean the air intake channel. Vacuum the combustion residues located under the
burn pot. On the following view this is the hatched area.
46
Cambridge Pellet Stove Installation and Operation Manual
Advertisement
Table of Contents
