Enerzone Cambridge EP00075 Installation And Operation Manual page 87

Wired thermostat
Before installing the thermostat, unplug the power cord from the power outlet.
First, connect the two thermostat wires to the terminal block located at the rear on the right hand
side of the stove when facing it. Loosen the two middle screws and insert the wires in the terminals.
Tighten the two screws. Open the thermostat and connect the wires as per the manufacturer's
instructions.
Connect one wire on "RH" and the other wire on "W". Red wire jumper can remain installed. For
further information refer to the manufacturer's instructions.
Wireless thermostat
If you are using a wireless thermostat or a hand held thermostatic remote control, connect the two
thermostat wires to the terminal block located at the rear on the right hand side of the stove while
facing it. If the receiver wires are equipped with quick-connect terminals you can connect them
directly to the stove's wiring harness.
To do so, open the right hand side decorative panels and disconnect wires (B) and (C) attached to the
rear of the terminal block (A) and connect them to the receiver.
87
Cambridge Pellet Stove Installation and Operation Manual