Testing Components; Main Error Codes, Possible Causes And Solutions - Enerzone Cambridge EP00075 Installation And Operation Manual

Table of Contents

9.2 Testing Components

If you suspect an electrical component to be defective, you can test it from the "TROUBLESHOOT"

page. From the Main Status Page, press the Settings icon

menu. Page 5 and 6 will allow you to test every electrical component. Note that you will be able to

test only components when the stove is OFF and that all the components are no more in function.

For example, if you press on the white square next to "GEAR MOTOR 1", the auger 1 will turn for 30

seconds. This will give you the possibility to see the auger running and hear the motor running as well.

RISK OF ELECTRICAL SHOCK. IF YOU NEED TO MANUALLY TEST, MANIPULATE OR REPLACE

ANY COMPONENTS, THE STOVE NEEDS TO BE DISCONNECTED FROM THE WALL OUTLET.

This section contains main error codes, possible causes and many suggestions to guide you in

resolving them. After giving an error code, your stove will shut down by itself and start a cool down

cycle. If you want to start your stove again, you will need to press on the

then on the "ON/OFF" button

completed.

NOTE: IF, AFTER PERFORMING ALL THE POSSIBLE SOLUTIONS MENTIONED IN THE FOLLOWING

SECTION, YOU ARE STILL EXPERIENCING PROBLEMS WITH YOUR STOVE, CALL YOUR LOCAL DEALER

OR A SERVICE TECHNICIAN AT (418) 908-8002. YOU CAN ALSO WRITE AN EMAIL TO:

tech@sbi-international.com

NOTE: IF YOU NEED TO CONTACT YOUR DEALER OR TECHNICAL SUPPORT, MAKE SURE TO HAVE THE

MODEL OF YOUR STOVE AND THE SERIAL NUMBER ON HAND. (THEY CAN BE FOUND ON THE

CERTIFICATION LABEL INSIDE THE HOPPER LID).

WARNING

. Your stove will only restart when the cool down cycle is

Cambridge Pellet Stove Installation and Operation Manual

and choose "TROUBLESHOOT" in the

RESET

button and

Table of Contents