Figure 25: Configuration Reboot - Motorola Canopy 300 Mbps Backhaul User Manual

connected equipment, its automatic configuration mechanisms will normally cause a
duplex mismatch, and you will receive greatly reduced throughput!
When Ethernet Auto Negotiation is Disabled the format of the LAN configuration page will
change see Section 8.3.1.4 " LAN Configuration Page – Manual Ethernet Configuration ".
Auto Neg Advertisement This controls the rates that the auto negotiation mechanism will
advertise as available.
Warning: Over the air throughput will be capped to the rate of the Ethernet interface at
the receiving end of the link.
Ethernet Auto MDIX This enables/disables the Auto Medium Dependent Interface
(MDI)/Medium Dependent Interface Crossover (MDIX) capability.
Drop Ethernet Link On Wireless Link Down When this option is enabled the Ethernet link is
momentarily dropped when the wireless link goes down. This feature is used to indicate to the
connected network equipment that this Ethernet link is no longer available, thus causing STP
(Spanning Tree Protocol) to re-route packets through an alternate link.
Local Packet Filtering When Local Packet Filtering is Enabled, the bridge learns the source
MAC addresses of devices transmitting Ethernet packets on the local Ethernet network, and
only bridges packets to the remote unit if the destination MAC address has not been learnt as
a 'local' device. When Local Packet Filtering is Disabled the bridge does not learn the source
MAC addresses of devices transmitting Ethernet packets on the local Ethernet network, and
bridges ALL Ethernet packets received to the remote unit. Local Packet Filtering should only
be disabled when external routing hardware is present.
All of the above attributes are non-volatile, once set they will be used by the unit even after a
power on reboot. A number of attributes, such as IP Address, Subnet Mask and Gateway IP
Address and VLAN settings will require a reboot before they are used. If any of these
attributes are changed a reboot screen appears asking the user to verify the reboot (Figure
25 or Figure 26 )
Figure 25: Configuration Reboot Page
Issue 1.1 April 2006 Page 61