Motorola Canopy 300 Mbps Backhaul User Manual page 120

Power Indoor Unit LED check chart:
Mode
No Power Applied
Power Applied
Valid Ethernet Link
and no traffic
Valid Ethernet Link
with traffic
Recovery Switch
Pressed and held
for >10 seconds
from power on
(Recovery is
pressed whilst
power is applied)
Issue 1.1 April 2006
Yellow LED No Ethernet
Green LED
Cable Connected
Off Off
Will flash once per second
regularly approximately 30
On seconds after power
applied for 10 seconds then
will go out and stay out
On N/A
On N/A
Off whilst switch pressed.
Approximately 30 seconds after releasing the
switch, flashes twice per second regularly for 10
seconds, then boots in "Recovery Mode"
On
Whilst in "Recovery Mode" the unit will only be
accessible via the IP address169.254.1.1.
Yellow LED
Ethernet Cable
Connected between
Canopy 150/300
PIDU and
NIC/Switch/Hub
Off
Will flash once per
second regularly
approximately 30
seconds after power
applied for 10
seconds then operate
as Ethernet
Link/Activity LED
Will be on solid for a
valid link.
Will be on solid, but
will blink randomly as
traffic passes through
Page 119