of the wireless link not the maximum potential capacity of the link as displayed by link
capacity.
Transmit Modulation Mode The modulation mode currently being used on the transmit
channel. Details on the modulation modes can be found in section 11.1 "System
Specifications ".
The data used to compute the histogram statistics can be downloaded in an ASCII comma
separated variable (CSV) format via the download diagnostics page, see section 8.3.12
Receive Modulation Mode The modulation mode currently being used on the receive
channel. Details on the modulation modes can be found in section 11.1 " System
Specifications ".
The data used to compute the histogram statistics can be downloaded in an ASCII comma
separated variable (CSV) format via the download diagnostics page, see section 8.3.12
Receive Modulation Mode Detail This supplies the user with information regarding the
receive modulation mode in use. Possible values are:
•
Running at maximum receive mode
•
Running at user-configured Max Modulation Mode
•
Restricted due to byte errors on the wireless link or local Ethernet Tx Fifo Drops
•
Restricted because a DFS channel change is in progress
•
Restricted due to telecoms acquisition mode
•
Restricted due to the low Ethernet link speed
•
Limited by the wireless conditions
Range The range
Refresh Page Period The Status page refreshes automatically according to the setting
entered here (in seconds). This attribute is only displayed when the user is logged on as
System Administrator.
6
The Canopy 150/300 Mb BH displays range in km by default, if the user would prefer to display
T P
P T
range using Miles the 'Distance Units' attribute should be set to imperial, see the "Properties"
webpage section 8.3.15
Issue 1.1 April 2006
6
between the peer Canopy 150/300 Mbps Backhaul units.
FP T
Page 56