Initial Access Point Configuration - Motorola AP6562 Installation Manual

Installation Guide

3 Initial Access Point Configuration

Once the access point is installed and powered on, complete the following steps to get the device up and running
using the Initial Setup Wizard:
1. Attach an Ethernet cable from the access point to a controller with an 802.3at compatible power source
or use the PWRS-14000-148R power supply to supply power to the AP6562 (once fully cabled).
If your host system is a DHCP server, an IP address is automatically assigned to the AP6562 and can be
used for device connection. However, if a DHCP server is not available, you'll need to derive the IP address
from the AP6562 MAC address. Using this method, the last two bytes of the AP6562 MAC address become
the last two octets of the IP address.
AP6562 MAC address -
AP6562 IP address equivalent -
To derive the AP6562's IP address using its factory assigned MAC address:
a. Open the Windows calculator be selecting Start > All Programs > Accessories > Calculator. This menu
path may vary slightly depending on your version of Windows.
b. With the Calculator displayed, select View > Scientific. Select the Hex radio button.
c. Enter a hex byte of the AP6562's MAC address. For example, F0.
d. Select the Dec radio button. The calculator converts F0 into 240. Repeat this process for the last
AP6562 MAC address octet.
2. Point the Web browser to the AP6562's IP address (using https://). The following login screen displays:
3. Enter the default username admin in the Username field.
4. Enter the default password motorola in the Password field.
00:C0:23:00:F0:0A
169.254.240.10
23