Table of Contents
Advertisement
16
E1/T1 Installation Guide
16.1 Preparing the Canopy 150/300 Mb BH E1/T1 Cable
Note: The maximum cable length between the ODU and the customers terminating
equipment is 200m for T1.
The E1/T1 cable should be assembled to the following instructions:
Step 1: Assemble gland on cable as shown
Step 3: Arrange conductors as shown in
figure A2 and cut to length
This procedure applies to the ODU termination. The above procedure should be repeated for
the customer equipment end of the cable when the cable is terminated with a RJ45.
Issue 1.1 April 2006
Figure A1: Completed ODU connector
Step 2: Strip the outer insulation
Step 4: Insert conductors and crimp
Page 152
Advertisement
Table of Contents
