Table of Contents
Advertisement
8.3.1.3 LAN Configuration Page – Use VLAN For management Interfaces
The layout of the LAN Configuration page changes if this attribute is enabled in order to allow
the VLAN VID and VLAN Priority to be set, see Figure 27 . The VLAN settings are applied
only after the unit is rebooted.
Warning: You must ensure that you can access the VLAN which you configure here;
otherwise you will be unable to access the unit following the next reboot.
VLAN Management VID This 802.1Q VLAN VID will be included in packets generated by the
management interfaces. Valid settings are in the range 0 to 4094.
VLAN Management Priority This 802.1Q VLAN Priority will be included in packets
generated by the management interfaces. Valid settings are in the range 0 to 7.
VLAN Management VID Validation If enabled, the management interfaces will only respond
to Ethernet packets tagged with the configured 802.1Q VLAN Management VID, otherwise
packets with any VID will be accepted.
Issue 1.1 April 2006
Figure 27: VLAN Configuration Fields
Page 63
Advertisement
Table of Contents
