Upgrade Software Image - Motorola Canopy 300 Mbps Backhaul User Manual

The recovery options available are:
Upgrade Software Image This allows the user to reload a software image. This may be the
original image if software corruption is suspected or a step back to an old image if an
incorrect image has just been loaded.
Reset IP & Ethernet Configuration back to factory defaults This allows the user to reset
the unit back to the factory defaults:
•
IP Address
•
Netmask
•
Gateway
•
Ethernet Interface Auto-negotiate, Auto-MDI/MDIX
Erase Configuration This allows the user to erase the unit's entire configuration. Executing
this options will also erase factory setting such as target MAC address, range setting, license
key etc.
Reboot This allows the user to reboot the unit. This option must be executed after resetting
the IP & Ethernet configuration or erasing the configuration detailed above.
Software Version This is the software version of the recovery operating system permanently
installed during manufacture.
Recovery Reason Indicates the reason the unit is operating in Recovery mode. Possible
reasons are "Recovery button active" or "Invalid or corrupt image"
MAC Address The MAC address shown here is the MAC address of the unit programmed
during manufacture.
9.1

Upgrade Software Image

The first step is to use the 'Browse' button to locate the software image to be downloaded.
Once located the user should press the "Upgrade Software Image" button to start the
software download process.
Issue 1.1 April 2006
Figure 74: Recovery Options Page
169.254.1.2
255.255.0.0
169.254.1.1
Page 110