Passing Make Contact; Delay - Reer Mosaic MI8 Installation And Use Manual

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC

PASSING MAKE CONTACT

In the PASSING MAKE CONTACT operator the
output follows the signal on the input.
However, if this is 1 (TRUE) for longer than the
set time, the output changes to 0 (FALSE).
When there is an input falling edge, the timer
is cleared.
Parameters
Time: The delay can be set to between 10 ms and 1098.3 s.
Retriggerable: If selected the time is not reset when there is an input falling edge. The
output stays 1 (TRUE) for all the selected time. When there is a new input rising edge, the
timer restart again.

DELAY

DELAY operator applies a delay to a signal by
setting the output to 1 (TRUE) after the set
time, against a change in the level of the
input signal.
Parameters
Time: The delay can be set to between 10
ms and 1098.3 s
.
8540780 • 23/03/2017 • Rev.31 139