MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
Click the "X" key (top right) to exit the graphic simulation environment.
Figure 74 – Example of a result of the graphic simulation.
It shows the traces and the three keys in the bottom right corner for selecting the
traces, saving and printing.
The simulation can only be carried out after performing at least the following steps.
1. Create a stimuli file to suit your needs.
2. Upload the stimuli file and wait until the simulation finishes.
Click on the
icon to display the page shown below.
Figure 75 – Menu for selecting the graphic simulation mode
8540780 • 23/03/2017 • Rev.31
159