Panel Cutouts - GE N60 Instruction Manual

PANEL CUTOUTS

3.2 Panel cutouts
This section does not apply to the HardFiber Brick; see its instruction manual.
The N60 is available as a 19-inch rack horizontal mount unit with a removable faceplate. The faceplate can be specified as
either standard or enhanced at the time of ordering. The enhanced faceplate contains additional user-programmable
pushbuttons and LED indicators.
The modular design allows the relay to be upgraded and repaired by qualified service personnel. The faceplate is hinged to
allow access to the removable modules, and is itself removable to allow mounting on doors with limited rear depth.
The case dimensions are shown in the following figure, along with panel cutout details for panel mounting. When planning
the location of your panel cutout, ensure that provision is made for the faceplate to swing open without interference to or
from adjacent equipment.
3
The relay must be mounted such that the faceplate sits semi-flush with the panel or switchgear door, allowing the operator
access to the keypad and the RS232 communications port. The relay is secured to the panel with the use of four screws
supplied with the relay.
6.995"
[177,67 mm]
3-2
Figure 3-1: Horizontal dimensions (enhanced panel)
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INSTALLATION
17.56"
[446,02 mm]
19.040"
[483,62 mm]
11.016"
[279,81 mm]
9.687"
[246,05 mm]
7.460"
[189,48 mm]
6.960"
[176,78 mm]
842807A1.CDR