Setting Groups - GE N60 Instruction Manual

CONTROL ELEMENTS
TRIP BUS 1 LATCHING
required or user acknowledgement of the relay response is required.
— The trip bus output is reset when the operand assigned to this setting is asserted. Note that the
TRIP BUS 1 RESET
operand is pre-wired to the reset gate of the latch, As such, a reset command from the front panel interface or via
communications resets the trip bus output.
SETTINGS
TRIP BUS 1 INPUT 1
TRIP BUS 1 INPUT 2
TRIP BUS 1 INPUT 16
SETTINGS
TRIP BUS 1
FUNCTION
TRIP BUS 1 BLOCK
SETTINGS
TRIP BUS 1
LATCHING
TRIP BUS 1 RESET
5
FLEXLOGIC OPERAND
RESET OP

5.8.3 Setting groups

SETTINGS  CONTROL ELEMENTS  SETTING GROUPS
 SETTING GROUPS

The setting groups menu controls the activation and deactivation of up to six possible groups of settings in the
settings menu. The active setting group can be indicated on the front display of the UR by configuring User-
ELEMENTS
Programmable LEDs to display the state of the
5-190
— This setting enables or disables latching of the trip bus output. This is typically used when lockout is
Figure 5-93: Trip bus logic
= Off
= Off
OR
AND
= Off
= Enabled
AND
= Off
= Enabled
= Off
OR
SETTING GROUPS

FUNCTION: Enabled
SETTING GROUPS BLK:

Off
GROUP 2 ACTIVATE ON:

Off
GROUP 6 ACTIVATE ON:

Off
GROUP 1 NAME:

GROUP 6 NAME:

SETTING GROUP

EVENTS: Disabled
SETTING GROUP ACT
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
SETTINGS
TRIP BUS 1 PICKUP
DELAY
Non-volatile,
TRIP BUS 1 RESET
set-dominant
DELAY
S
T
PKP
Latch
R
Range: Disabled, Enabled
Range: FlexLogic operand
Range: FlexLogic operand

Range: FlexLogic operand
Range: up to 16 alphanumeric characters

Range: up to 16 alphanumeric characters
Range: Disabled, Enabled
FlexLogic operands.
CHAPTER 5: SETTINGS
FLEXLOGIC OPERAND
TRIP BUS 1 OP
T
RST
FLEXLOGIC OPERAND
TRIP BUS 1 PKP
842023A1.CDR
GROUPED
RESET OP