Table of Contents
Advertisement
Installing External Ferrite Clamps
Installing External Ferrite Clamps
This section describes how to install an external ferrite clamp-on (P/N 115346-G1) that
Introduction
is required when the 61000 mainframe is configured with more than 2 modules. When
the mainframe is equipped with more than 2 modules this filter is required for any slots
that are configured for modules 61MVS, 61MVB, or 61MDIN to meet emissions/
immunity compliance requirements. For these factory configurations, a ferrite clamp-
on is supplied for each applicable module to be installed over factory or customer-
supplied wires as described in this section.
Disconnect all power sources connected to the instrument before installation of filter
Warning
parts.
This equipment has been tested and found to comply with emissions and/or immunity
Caution
requirements. The ferrite clamp-on must be installed before operating the equipment
since failure to do so may result in undesired interference.
61MVB Module
Installation
Procedure
STEP 1: The clamp-on ferrite (P/N 115346-G1) is supplied with both halves secured.
STEP 2: Place ferrite clamp-on over all wires to the module so that all wires pass
STEP 3: Snap the ferrite clamp-on closed until it is fully secured.
Actual photo below shows the ferrite clamp-on properly installed for 61MVB Module.
External Ferrite Clamp-On
Unsnap the halves of the ferrite clamp-on and open it.
through the center.
A
D
P PE N D IX
Continued on next page
D-1
Advertisement
Table of Contents
