Table of Contents
Advertisement
Configuring the Encore 61000 DataNode for Modem Communication, continued
Procedure
(continued)
Enable to enter
your IP address
STEP 5: Set up the 61000 DataNode in Encore Series Software.
4-14
4.8 Check to enable Internet Protocol (TCP/IP) then click on the Properties
button. The following screen will appear:
4.9 Select Use the following IP address to set up the IP in a range compatible
with the range of the 61000. Once you click on the radio button, the field
to enter the IP address will be enabled.
4.10 Enter the default IP address 192.168.1.101 into the IP address box, or
whatever the Modem IP address was programmed in Step 3.
5.1 The 61000 DataNode can now be added to the Encore Series Software
system as a DataNode using modem communications.
5.2 Dial-up networking name and settings are automatically detected by the
Encore Series Software and will appear under the Network Connections
folder.
5.3 In the setup tree and in the drop-down box under the Communication tab,
select the desired dial-up site for the appropriate DataNode.
Enter default IP address:
192.168.1.101
Continued on next page
Advertisement
Table of Contents
